First, remove the sill plate that runs alongs the drivers door opening nexto to the seat - grab it back by the B - pillar and gently lift up on it. It snaps in all the way to the kick panel so you have to gently work it free, paying extra attention to the area where the still plate attaches to the kick panel.
With the sill plate out of the way you can remove the drivers side kick panel. There is a plastic nut behind the dead pedal that can be unscrewed. Then there are just a few clips that hold it in - pull the kick panel towards the center of the dash and it should pop right off.
Once the kick panel removed from the car you will see a screw holding the drivers side lower dash in place - remove this screw and one other screw from the bottom of the lower dash panel and the entire lower dash can be pulled down.
After the dash has been dropped down you can access the wiring on the back of the VDC switch. Here you will make two connections. Connect the black wire (ground) to the KPtechnologies black wire. Connect the blue with yellow stripe wire (VDC Switch Signal) to KPtechnologies orange wire.
DONE
No comments:
Post a Comment